Samson 3730-2, Монтаж и эксплуатация

Страница: 71 / 128

EB 8384-2 EN 71
Start-up and settings
Select the initialization mode:
Init mode
Default MAX
Turn

Code 6
Press , Code 6 blinks.
Turn

MAN
Press to confirm the MAN as the initial -
ization mode.
Enter OPEN position:
Manual set point
(current angle of rotation is
indicated)
Turn

Code 0
Press , Code 0 blinks.
Turn

MAN
Press .
Turn

Code 1
Press , Code 1 blinks.
Turn until the valve reaches its OPEN po-
sition.
Press
to confirm the OPEN position.
Start initialization:
Î
Press INIT key.
7.6.4 SUb – Substitute calibra-
tion
A complete initialization procedure takes
several minutes and requires the valve to
move through its entire travel range several
times. In the SUb initialization mode, the
control parameters are estimated and not
determined by an initialization procedure.
As a result, a high level of accuracy cannot
be expected. A different initialization mode
should be selected if the plant allows it.
The substitute calibration is used to replace a
positioner while the process is running. For
this purpose, the control valve is usually fixed
mechanically in a certain position, or pneu-
matically by means of a pressure signal
which is routed to the actuator externally.
The blocking position ensures that the plant
continues to operate with this valve position.
By entering the blocking position (Code 35),
closing direction (Code 34), pin position
(Code 4), nominal range (Code 5) and di-
rection of action (Code 7), the positioner can
calculate the positioner configuration.
Perform a reset before re-initializing the po-
sitioner if the substitute positioner has al -
ready been initialized. Refer to section 7.8.
Enable configuration:
If no settings are entered within 120 sec-
onds, the enabled configuration function be-
comes invalid.
NOTICE !
Note