www.larius.com
12
GIOTTO FOR SANITATION
REV. 01 - 04/2020 - Cod. 150113
ON
I5
I4
Fig. 6I
I6
Fig. 7I
Fig. 8I
I
• Make sure that the product recirculates from the tube and
then close the recirculation valve.
• Point the gun at a container keeping the trigger pressed (
so
as to drain the oil inside
) till a clean solvent comes out. Now,
release the trigger.
• Remove the suction pipe and take away the solvent tank.
• Point the gun at the solvent tank and press the trigger so as
to recover the residual solvent.
• As the pump idles, press the ON/OFF switch (
I5
) on the
position “
OFF
”
(0)
to stop the tooling.
• Now the machine is ready.
• Insert the gun trigger lock and assemble the nozzle.
• Never use products containing halogen hydrocarbons with
percentages above 1% (
as Methylene Chloride
). If these
products come into contact with aluminium parts of the
equipment, can provoke dangerous chemical reactions with
risk of explosion.
WASHING OF THE NEW EQUIPMENT
• The equipment has already been adjusted at our factory with
light mineral oil left inside the pumping group as protection.
Therefore, wash with diluent before sucking the product.
• Lift the suction pipe and dip it into the solvent tank.
• Ensure the gun (
I4
) is without nozzle.
• Open the re-circulation tap.
Turn the unit ON-OFF switch (
I5
) on the “
ON
” position
(I)
.
• Rotate the pressure setting knob (
I6
) slightly clockwise so
that the machine operates at minimum power.
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact between
the solvent fumes and the electric motor.
Make sure the product to be used is compatible
with the materials employed for manufacturing
the equipment (
stainless steel and aluminium
).
Because of that, please contact the supplier of
the product.
Содержание LARIUS GIOTTO
Страница 30: ...I n t e n t i o n a l l y b l a n k p a g e...
