* The company reserves the right to change product design and specifications, and takes no responsibility for printing errors and
omissions that may occur at the public division.
* Since technologies are developing continuously, the corresponding changes of product design and specifications will go without
notice.
* The reproduction of this manual in part or entirety without permission is strictly prohibited.
* Our company reserves the right of final explanation to these commitments above.
FCC requirement
This radio has been tested and complies with the FCC RF exposure limits for "General population". In addition,
Your SANCON radio complies with the following Standards and Guidelines with regard to RF energy and
electromagnetic energy levels and evaluation of such levels for exposure to humans:
KDB 865664 D01 SAR measurement 100MHz to 6 GHz v01ro3, Evaluating Compliance with FCC
Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields.
●
American National Standards Institute ( C95.1-1992), IEEE standard for safety Levels with Respect
to Human Exposure to Radio Frequency Electromagetic Fields, 3KHz to 300GHz.
●
A
i
N ti
l St
d d I
tit t ( C95 1 1992) IEEE
d d
ti
f
●
American National Standards Institute ( C95.1-1992), IEEE recommended practice for
the Measurement of potential Y hazardous Electromagnetic Fields- RF and Microwave
To ensure that your exposure to RF electromagnetic energy is
within the FCC allowable limits for general population use,
always adhere to the following CAUTION guidelines:
●
DO NOT
operate the radio without a proper antenna attached, as this
may damage the radio and may also cause you to exceed FCC RF
RF exposure limits. A porper antenna is the antenna supplied with this radio by the manufacture or
an antenna specifically authorized by the manufacturer for use with this radio.
●
DO NOT
transmit for more than 50% of total radio use time " 50% duty cycle'
Transmitting more than 50% of the time can cause FCC RF exposure compliance
reqirements to be exceeded. The radio is transmitting when the " TX indicator" lights red.
you can cause the radio to transmit by pressing the "PTT" switch or " Group" button.
CAUTION
