Transmitting
while holding down the PTT button. The transmission indicator turns red when the PTT button is pressed.
If you speaks too loud or with your mouth getting too close with the microphone, it may distort the sound
and reduce the signal clarity on the receiving side. Release the PTT button to listen to the partner's voices.
Receiving
Release PTT key, transceiver enter the receiving mode, the status indicator lights green. Please adjust the volume
appropriately to achieve the best listening effect.
Low Battery Warning
Low battery warning happens at the time when the battery needs charging or replacement.
Additional function
■
Time out timer ( TOT )
(
)
TOT is the optional function set by programmer. If TOT is available, transmission time ( hold the PTT button ) will be
limited on certain period of time.
TOT is useful for preventing from the thermal damage when Transceiver is under long time transmission.
■
Scan
Scan is the optional function set by programmer. If scan function is available, transceiver can stop the any of channel which are busy.
This scan function can be set only for No.20 channel, so you can monitor maximum of 20 channel with scanning mode.
When channel is stop at certain channel, you can press the PTT button to transmit. Also press and hold the Monitor button
to stop scan operation.
■
Battery Saving
This is a standard function. To increase the battery life ( decrease battery consumption ) , Transceiver has battery saving mode
Battery saving mode will start after 10 seconds from the busy condition off.
■
CTCSS / CDCSS
CTCSS can be set by programmer.
If equipped with CTCSS or DCS, your group can not listen other group conversation. This function is useful to listen the voice within
the group even other group are using same channel.
