Operator's Manual
Front disc mowers
TORO
- 25 -
1
2
3
6 4
7
5
Fig. 25.
Adjustment of swath guides: 1 - swath guide, 2 - locknuts, 3
–
arm adjustment screws, 4 - locknuts,
5
–
shield adjustment screws, 6
–
guide arm, 7
–
shield
6.5.
Maintenance and service
6.5.1.
Daily maintenance
When you finish each day of operation carry out the following maintenance:
check all visible parts and components and their connections; tighten all
loose bolt connections and nuts and replace all damaged and/or worn parts with new genuine ones,
clean the mower from any soiling,
wash the mower with pressurized water after each operation, especially between discs and
cutterbar, because grass with mud may damage bearings in disc module,
check the cutterbar,
grease PTO shaft tubes with STP grease.
6.6.
Storing of the machine
Store the disconnected mower in standstill position, so that the mower
’
s cutterbar is on the
ground. Store the aggregate on a paved ground, best if under roof, in places inaccessible to
unauthorised persons and animals. Store the machine in a dry place, and if it is exposed to any
precipitations bear in mind its periodic lubrication.
If the machine is stored for a long period of time before first operation:
Check the mower's technical condition, and the drive in particular,
Paint the area where the paint is missing,
Make sure that all nuts and screws are tightened properly,
Make sure that all guards are in place,
Protect all operating parts with grease in order to prevent their baking and creating any sources
of corrosion, which significantly influences mower's proper operation,
Check oil level in axis gears and cutterbar. If leaks are found remove them immediately and
refill the oil. If water in oil is discovered, immediately change the oil as it could cause corrosion
of internal mechanisms such as gear wheels, bearings, or shafts, and cause breakdowns.
