Operator’s manual
Double-sided disc mowers
with central suspension
- 35 -
5.3.5.
Description of errors
Errors are displayed as “
Errx”
(
x
is error no.) alternately with parameter value. If multiple
errors occur at the same time, they are displayed sequentially, e.g. for errors 1, 3 and 5:
Err1 ->
750 -> Err3 -> 650 -> Err5 -> P30
etc.
Tab. 5.
Possible displayed errors
Error:
Cause:
Err1*
improper speed of main PTO shaft
Err2*
speed of left PTO shaft below speed of main PTO shaft
Err3*
speed of right PTO shaft below speed of main PTO shaft
Err4
too low pressure in unloading system of left cutterbar
Err5
too low pressure in unloading system of right cutterbar
* Errors concerning PTO speed (
Err1, Err2, Err3
) are registered and displayed only if speed of main PTO
shaft is greater than 600 rpm.
II.
PARAMETER PREVIEW MODE
5.3.6.
Work parameter overview
To enable work parameter preview turn on the controller with
ON/OFF
switch, and then hold
button (
2
)
The displayed parameter can be changed by pressing button (
2
)
.
Tab. 6.
Work parameters
Parameter: Opis:
Current PTO rpm at gearbox input. (90 rpm)
Current PTO rpm of left cutterbar. (90 rpm)
Current PTO rpm of right cutterbar. (90 rpm)
Current pressure in unloading system of left cutterbar. (120 bar)
Current pressure in unloading system of right cutterbar. (120 bar)
Changeable working pressure in left unloading system. (120 bar)
Values can be changed using button (
3
)
to decrease and button (
4
)
to increase. After
button (
1
)
is pressed the set value is confirmed which is indicated by message
“SAFE”.
Changeable working pressure in right unloading system. (120 bar)
Values can be changed using button (
3
)
to decrease and button (
4
)
to increase. After
button (
1
)
is pressed the set value is confirmed which is indicated by message
“SAFE”.
To exit work parameter overview function press button (
1
)
.
III.
TEST MODE
5.3.7.
Controls testing
To test individual controls turn on the controlled with
ON/OFF
switch, and then hold buttons
(
3
)
and (
4
)
simultaneously. The display will show message “
tESt
”.