Operator’s manual
Double-sided disc mowers
with central suspension
- 32 -
5.2.3.
Starting the conveyer’s belt
To turn rears of conveyor's belt and start left conveyor (
L
) press button (
12
)
until the
diode lights up. Analogically, when button (
13
)
is pressed, the corresponding diode is lit
up, which starts the right conveyor (
R
). Turning conveyors off is possible owing to pressing again
the buttons responsible for turning conveyors in
Fig. 16
. Rotations of conveyors' belts are adjusted
with button (
5
)
- causing increase in speed of belt rotation or button (
6
)
- causing reduction
in swath conveyors' rotation speed.
5.2.4.
Changing language version of control panel
On the control panel, it is possible to change language version for descriptions of the displayed
options. In order to change, press button
MENU
(
20
)
. . Navigation through the option list is
performed by means of buttons (
9
)
and (
20
)
. To confirm your choice, use button (
21
)
.
Press button (
22
)
to leave the options menu.
5.2.5.
Service mode
When service mode is selected from the control panel, it is possible to check the mower's
serial number and work time, i.e. machine's man-hour time. To run service mode, turn off the panel,
and press buttons (
1
)
and (
2
)
at the same time until information is displayed on the
information screen (
4
). To exit the service mode, turn off the panel and on again with power switch
(
Fig. 17a
).
5.3.
Simplified control panel
The control system comprises controller, controls (sensors, solenoid valves, etc.) installed on
the machine and control panel (
Fig. 18
).
On the upper wall the panel has
ON/OFF
switch (allowing for its switching on/off), display
and 7 buttons.
During normal operation with two cutterbars (no selected function on the controller), the
operator handles only the section of distributor to which the main hydraulic system of the machine
(section with floating function) is connected. After the distributor lever is switched oil is fed to the
machine control system which results in lifting of its cutterbars to headland position. After the
distributor lever is switched back to the floating position, the cutterbars are lowered to to working
position. To using functions, select a corresponding function on the controller and then switch the
distributor lever on the tractor, select a corresponding function on the controller and then switch the
distributor lever on the tractor..
If the machine is equipped with hydro unloading system to adjust it use the lever of the other
distributor on the tractor to which the unloading system was connected.
After enabling the control panel with
ON/OFF
switch, on the display red decimal point will
flash in the last position indicating that power supply is fed and the controller is ready for operation.