Operator’s manual
Double-sided disc mowers
with central suspension
- 34 -
5.3.2.
Lifting of cutterbars to headlands
After button (
3
)
or (
4
)
(diode will light up green) is pressed only
left cutterbar
or
right cutterbar
can be operated (lifting to maximum to headland position), e.g. to pass an obstacle.
After button (
3
)
or (
4
)
is pressed again (diode will turn off) the controller will return to its
previous condition (possibility of operating two cutterbars).
NOTICE:
Function 3 can be enabled on condition the
left cutterbar
is not locked (diode at button
(5)
is off).
Function 4 can be enabled on condition the
right cutterbar
is not locked (diode at button
(6)
is off).
When function 3 is being enabled, function 4 is disabled, and when function 4 is being
enabled, function 4 is disabled (if enabled).
5.3.3.
Locking cutterbars in lifted position
After button
(5)
(is pressed (diode blinks red)
left cutterbar can be locked
in lifted
position during operation with only
right cutterbar
.
After button
(6)
is pressed (diode blinks red)
right cutterbar can be locked
in lifted
position during operation with only
left cutterbar
.
After button (diode will turn off) is pressed again the lock will be released and the controller
will return to its previous condition (possibility of operating two cutterbars).
When
left cutterbar lock
is enabled (function 5) function 1 is disabled (unloading should be
adjusted only when cutterbar is in working position) and function 3. Function 5. (
left cutterbar
lock
)
has a priority higher than function 3 and thus it is not possible to select function 3 when the
lock is enabled.
When
right cutterbar lock
is enabled (function 6) function 2 is disabled. (unloading should
be adjusted only when cutterbar is in working position) and function 4. Function 6. (
right
cutterbar locks
) has a priority higher than function 4 and thus it is not possible to select function 4
when the lock is enabled.
5.3.4.
Lifting cutterbars to transport position
After button
(7)
is pressed, arm position sensors are disabled which allows for folding of
the machine to transport position. When function 7 is enabled other functions (if enabled) are
disabled and locked, and the display alternately shows the following symbols:
and
.
Lifting of cutterbars to transport position is possible only when PTO shaft rpm is zero
(protection against machine damage).
When button
(7)
is pressed again the sensors (cutterbars can be lifted only to headland
position) are activated, and thus machine folding to transport position is disabled.