Operator's manual
Arm
Flail head
- 55 -
7.
LUBRICATING
For lubrication joints of the machine use greases STP. Lubricate bearings of gear operation
with ŁT43. Do not use any plant or animal based grease. Prior to applying the grease clean out grease
fittings as well as lubrication points prior to grease application.
The following should be lubricated:
rolling bearings of cutterbar rotor,
joint pins.
After 2 h of operation:
make sure whether nuts, pipe fittings and clips are well tightened.
Every 4 h of operation:
apply grease into permanent grease fittings.
Every 8 h of operation:
lubricate all eyes of hydraulic cylinders,
examine pressure oil filter sucking (if the indicator is in red apply a new insert),
examine proper operation of Bowden lines (if any line cuts occur, lubricate).
After 100 h of operation:
check oil level in multiplier (if the level is too low refill with SAE 90 type oil or similar).
After 600 h of operation:
replace oil in multiplier (SAE 90).
Tab. 7. Torque values for bolts
