Sirius 800 Series User Manual
Nucleus 2450 Router Controller Card
Nucleus Router Control Modules 14.5
Iss 5 Rev 7
Page 282
© 2017 SAM
14.5.7 Nucleus 2450: Setting the Network Communication Speed
The Nucleus 2450 network communication speed is set in the controller Network.ini file. The
Nucleus 2450 controller network speed must be set to 10 Mbps, see section 14.5.4 for details.
14.5.8 Nucleus 2450: Enabling RollCall
RollCall is enabled by default. To use RollCall with the router the RollCall template files must
be loaded on the controller and RollCall must be enabled in the controller Network.ini file.
In the
[RollCall]
section of the ini file change
Enabled=0
to
Enabled=1
.
For details on editing the Network.ini files see section 14.5.5.
14.5.9 Nucleus 2450: Setting Parity for SW-P-02 & SW-P-08 Protocols
Parity can be changed for communication ports configured with SW-P-02 or SW-P-08
protocols (Nucleus 2450 only). Parity is set using the Workbench Generic Editor and can be;
Default, None, Even or Odd.
Using the Generic Editor Navigate to:
RouterController | Comms | Comms[1] to [4] (as required) |
CommsType: Serial | Parity=
Parity options are
:
•
Default
:
- SW-P-02 - Even
- SW-P-08 - None
•
None
•
Even
•
Odd
Push the new configuration to the controller (see the Workbench user manual for details).
In a dual controller system make the updated controller active, select it and click on the
Copy
to Partner
button to update the second controller.
14.5.10 Further Information
The Sirius 800 Maintenance & Upgrade manual contains details on updating the controller
software/firmware.
Note:
•
The default parity settings for the SW-P-02 and SW-P-08 protocol are correct when
used with SAM products and need not be changed.
•
Some third party products use a parity that is different from the default parity. In this
case the parity used by the SAM router controller can be changed to match the
third party product.
Note:
•
For a dual controller router systems select the inactive controller and set that one
first.
•
The new Parity setting will only take effect after the controller has been restarted.
