Sam Cook MASTERCHEF EXECUTIVE TERMOROBOT WiFi, Руководство пользователя

Страница: 34 / 42

EN
36
steamer container
steaming fish, vegetables - 10-60 minutes 110-120°C -
PREPARATION FOR USE --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1. Unpack the appliance from the cardboard,
remove all bags, labels, cardboard and
fillers. Check the appliance for any damage
that may have occurred during transport.
In case of any doubts, please contact the
seller.
2. Make sure that the parameters of your
mains supply correspond to the technical
data on the product rating plate.
3. Thoroughly wash and dry all parts in con -
tact with food following the instructions
in the section “CLEANING AND MAINTE -
NANCE”.
4. Place the appliance on a dry, flat, stable and
horizontal surface.
5. The appliance has a safety system - it can
only be switched on if the jig (8) and the jig
lid (2) are correctly fitted.
FITTING/REMOVING THE BOWL ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ATTENTION! Never run an incompletely
assembled appliance. Risk of injury!
1. Check that the seal is correctly fitted on the
drive shaft (25).
2. Insert the drive shaft (25) into the bowl so
that the sprocket goes through the hole
in the bottom of the bowl and then lock
the drive shaft by applying the lock (26) on
it from the outside and turning it slightly
clockwise (Fig.1)
3. Place the bowl (8) on the base unit (11) so
that the pins at the bottom of the bowl ad -
just to recesses in the base unit (picture 2).
4. Put one of the accessories on the installed
shaft (25) (Fig.3).

lightweight pulp- butterfly mixer (4)

mixer (5)

knife (6)

strainer (7).
ATTENTION! The knife blades are sharp. Be
careful not to get hurt!
5. Make sure that the seal (3) is properly seat -
ed in the bowl lid (2). It must be properly
seated in the groove for the seal around the
entire circumference.
6. Place the bowl lid (2) on the bowl (8) as
shown in Fig. 4, press it down and turn it
so that the handles of the bowl and the lid
overlap (the tabs in the lid will take their
places in the sockets of the bowl).
7. To remove the bowl from the appliance,
follow these steps:

remove the lid (21) and the tray (22)

turn the container (23) slightly counter -
clockwise so that the tabs in the container
slide out of the sockets in the bowl, care -
fully remove the container from the bowl

remove the bowl from the base of the
food processor

remove the knife from the rotary shaft.
Attention! The bowl may be disassembled
only when the lid is removed.