Tel: 886.2.2175 2930 Email: [email protected]
www.salukitec.com
69
6.
Push the CURSOR button to view the Cursor menu.
7.
Push the Type option button and select Time.
8.
Select Cursor S and turn V0 to place it on the active edge of the enable signal.
9.
Select Cursor E and turn V0 to place it on the data output transition (See the figure below).
10.
Read the data propagation delay in the Delta readout.
6.12
Example 12: Using Trigger to Measure Digital Signal
Edge Trigger
To observe digital signal by using the edge trigger, please use following steps.
1.
Push the TRIG MENU button to see the trigger menu.
2.
Push F1 button to select “Edge” as the trigger type.
3.
Push F2 button to select the trigger source (D0~D15).
4.
Push F3 button to select the trigger slope ( on rising edge or falling edge).
5.
Push F4 button to select the trigger mode : Auto or Normal
