Document Reference: ENG-UMAN-000731
Revision: 5.00
Page 35 of 61
Note: Feedback Control will only operate based on the settings in Stimulation Set A
(it will vary the current so that the ratio of current between Stimulation Sets
remains constant).
Figure 8.21: A Program with 4 Stimulation Sets configured at desired levels. Note that the
electrode settings from all Stimulation Sets are visible in the background while the active
set is displayed as normal.
8.13.2
Enable/Disable a Stimulation Set in a Program
To enable/disable a Stimulation Set in a Program:
1.
Select the Stimulation Set you want to enable/disable.
2.
Press
to enable the Stimulation Set or
to disable it. A disabled
Stimulation Set will have a red diagonal line across it, e.g.
.
3.
Start stimulation again when the desired changes have been made.
Note: The Stimulation Sets that are still enabled will continue to increase at the
previous ratio (Figure 8.22).
Note: If a Stimulation Set is disabled (
) its ratio will be set to 0 and it will need
to be reconfigured (refer to Section 8.13.3).
