Sakai SV410-2, Руководство по ремонту

Страница: 146 / 270

6-016
VIBRATORY DRUM • REAR AXLE
4) Apply an ample amount of lithium-based grease
to the rolling surfaces of the roller bearing (13).
Lightly apply the same grease to the lip surfaces
of the oil seal (12).
Join the axle shaft (32) subassembly and
housing (11).
Housing: 40 kg (88 lbs.)
5) After applying an ample amount of lithium-based
grease to the inner race of the roller bearing
(13), drive it in until the inner race’s rolling
surface makes contact with the outer race.
6) As shown in the figure on the right, insert
shims (31) approximately 1 mm to create a gap
between the axle shaft end face and cover (27)
interior surface. Then install the cover (27).
Install washers to the four bolts (23), and tighten
to a tightening torque of 108 N·m (80 lbf·ft).
Rotate the housing (11) two or three times. Then
tighten the same bolts again to a tightening
torque of 108 N·m (80 lbf·ft).
Repeat this procedure two or three times until
the bolt tightening torque no longer varies.
When tightening the bolts (23), alternately
tighten by using four of the eight bolts
positioned diagonally from each other.
•
•
•
•
•
SV400-2-06031
11
12
13
32
SV400-2-06031
11
12
13
32
SV400-2-06032
13
SV400-2-06032
13
SV400-2-06033
11
31
27
23
Gap
SV400-2-06033
11
31
27
23
Gap