SAJ SU3KMTLI, Руководство пользователя

Страница: 11 / 31

User Manual
15
User Manual
16
5.4 MOUNTING PROCEDURE
1. Use the rear panel in the package as a drilling template and mark the
positions of the drill holes, as illustrated below.
Sununo-TL1.5K/2K
2-
φ
8
346
280
2
6
8
2
3
0
Figure 5.3
S u n u n o - T L 3 K A / 4 K A
SU3KMTLI/SU4KMTLI
Sununo-TL/5K
SU5KMTLI
Sununo-TL3KB/4KB
346
280
3
0
4
2
3
0
2-
φ
8
8
280
16
2
9
4
2-
φ
9
9
290
19
2
9
4
2. According to the marks, drill 6 holes in the wall (in conformity with position
marked in above picture), and then place expansion tubes in the holes using a
rubber hammer.
Figure 5.4
Figure 5.6
Notch
3. Mount the rear panel.
Wring six screws into the expansion tubes and tightly mount the rear
panel on the wall.
Figure 5.5
4. Carefully attach the inverter to the rear panel according to the position of the
screws.Make sure the backside of the inverter is closely against the rear panel.
When two people transport the inverter, make sure each one use the hand grip in
right position as illustrated in the picture.
5. Pay attention to the four notches cut in both flanks of heat sink (as illustrated
in above picture), which should be placed in corresponding hooks from the rear
panel. Make sure that the heat sink and the rear panel are buckled together and
the inverter is tightly attached to the rear panel. And tighten the screws with
5.9N
·
m torque.