Saipa Tiba 2, Руководство пользователя

Страница: 51 / 147

4
51
Starting the vehicle
Engine in
flooding, push
the clutch pedal
and start
Engine in warm
,
push and hold all
the way down the
accelerator pedal
and start
OWM062
OWM063
Starting engine in flooding
If the engine is not starting due to
flooding with too much gasoline, do
the following steps:
1- Make sure the parking brake is
engaged.
2- Push the clutch and brake
pedals simultaneously and shift the
selector lever to neutral position.
When starting the engine push
down the clutch pedal.
3- Push and hold all the way down
the accelerator pedal.
4- While pushing all the way down
the accelerator pedal, start the
engine and hold the ignition switch
in the start position at most for ten
seconds.
Starting engine in warm
condition
When the engine is warm and does
not start normally (after several
times, starting without pushing the
accelerator pedal), do the following
steps:
Before starting again, wait for a
minute and ensure that the parking
brake is engaged.
1- Push the accelerator and
brake pedals all the way down,
and shift the selector lever to
neutral position .When starting
push the clutch pedal.
2- While pressing the
accelerator pedal half way, start
Attention
Do not hold the switch in the
START position for more than
ten seconds.
If the engine does not start or
gets off, restart the engine after
five to ten seconds.
Improper start of the engine
may damage the engine.
Abnormal noise of the engine
(from valves) may result from
being it off for a long time.
This noise goes off after the
engine temperature reaches
the standard limit. Otherwise,
consult an authorized SAIPA
YADAK dealer.
the engine (hold the ignition
switch in the START position for
ten seconds).
3- After starting the engine, wait
for ten seconds to drive.