Ultrafeed Industrial Table Set-Up Guide
| 8
Mounting the Thread Stand
Find the threaded insert and its corresponding
Allen wrench. Locate the pre-drilled hole (
F
) in
the tabletop just to the right of the belt slot
cutout. Use the Allen wrench to carefully screw
the threaded insert into the hole (
Figure 16
).
Note: Running a bar of soap along the threads
of the insert will help prevent the melamine
surface of the table top from cracking as the
insert is screwed in.
Sailrite's Integrated Thread Stand (not included)
can now be installed via the threaded insert
(
Figure 17
). If another thread stand is being
used, it can be placed on or screwed into the
table near this same location.
If you have the Ultrafeed Industrial Sewing Table
only (#120934), you won’t need to install the
foot treadle. The parts should be saved in case
a Workhorse Motor is added in the future.
If you purchased the Ultrafeed Industrial
Sewing Table & Workhorse Servo Motor
(#120931 or #121091), skip to page 10 to
complete the setup.
16
17
F
