9 |
Sailrite.com
Machine Installation
To remove the Ultrafeed from its carrying case
or wooden base, tilt the machine back and
loosen the two set screws (
A
) that hold the
machine on the hinges (
Figure 18
). Carefully
slide the sewing machine off the case/base
hinges.
Insert the chrome Euro hinges (
B
) into the two
holes on the back of the sewing machine head.
Carefully lift the sewing machine head and set it
in the cutout so the hinges rest in the hinge
cushions (
C
) (
Figure 19
). Tilt the sewing
machine back and tighten the set screws (
A
).
Plug in your foot control and you are ready to
sew! Assembly of the Ultrafeed Industrial
Sewing Table is complete.
18
19
B
C
C
A
A
Upgrade Options
To upgrade an Ultrafeed sewing machine with the
Industrial Sewing Table to the Workhorse Servo Motor
setup, the following add-ons can be purchased and the
remaining instructions followed:
• Sailrite Workhorse Servo Motor
#120260 (110V) #121091 (220-240V)
• Cogged Timing Belt 42" #120580
• Belt Cover & Bracket for Ultrafeed with Workhorse
#120930
• Support Pin for Sailrite Utlrafeed Industrial
Sewing Table #120866
• Idler Pulley for Ultrafeed #W061-A
Note: A new idler pulley is only required for Ultrafeed sewing
machines purchased prior to March 17, 2016.
