Sahara Sahara-Pak HC-1260, Инструкция по эксплуатации

Страница: 6 / 136

INSTRUCTION MANUAL
Model HC
Reference 219 Rev 2
Page 6 of 46 06/20/2013
SECTION 1:
INSTALLATION & START-UP
1.0
Installation
Connect the compressor interlock relay to compressor load condition, if
dryer load is less than 50%. Refer to the electrical drawing in Section 8.
This dryer is designed to be used only with a non-lubricated compressor.
Use with a lubricated compressor will void all warranties and may cause
severe damage.
Upon delivery of the dryer, it must be checked for damage that may have
occurred during transport. If there is any evidence of damage due to
shipping, immediately enter a claim with the carrier. Shipping damage is
not covered by warranty.
Use the appropriate, load-rated lifting equipment and observe safe lifting
procedures during all operations of installation. The equipment should be
unloaded as close as possible to the installation site to minimize any
chances of equipment damage.
If the dryer is to be stored for a prolonged period of time, it should be
stored in a dry place, preferably indoors, protected from the elements
including freezing or extremely warm temperatures. Keep all openings
closed until connections are made.
1.0.1 Dryer Location and Mounting Specifications
1.0.1.1 The Sahara-Pak HC dryer is designed for indoor operation with
ambient temperatures between 35

F - 100

F. The standard
electrical components are designed specifically for NEMA 4
(refer to the Specifications in Section 5). Should it be desirable
to locate the dryer outdoors, it would be necessary to protect
the dryer from rain by placing a roof over the dryer and to
protect cooling water and separator drain lines from freeze-up
by heat tape or other suitable means.
1.0.1.2 Locate the dryer as close to the air compressor as possible to
conserve "Heat-of-Compression" energy. Also, since the piping
from compressor to dryer requires insulation, a short run of
piping will simplify installation. Be sure that the intended
location allows for adequate clearance around the dryer to
facilitate servicing.