Sahara Sahara-Pak HC-1260, Инструкция по эксплуатации

Страница: 28 / 136

INSTRUCTION MANUAL
Model HC
Reference 219 Rev 2
Page 28 of 46 06/20/2013
2.1.2 Adjustments
The inlet air temperature (as indicated on the Instrument Panel) should
be adjusted to obtain the desired temperature/dew point performance
(refer to Specifications in Section 5). This can be accomplished through
manipulation of the inlet piping insulation and/or the compressor
intercooling.
The temperature of the air leaving the dryer aftercooler should be
maintained at or below 90

F. Adjust the cooling water supply as required.
2.1.3 Desiccant
2.1.3.1 Replacement / Disposal of Desiccant
The dryer is filled from the top and emptied from the bottom.
Refer to the General Assembly drawing in Section 8 for
location of fill and drain ports.
Advice for protection:

If desiccant comes into contact with the eyes, rinse eyes
immediately with large amounts of clear water.

If the desiccant is spilled, clean up with effort to minimize the
formation of dust.

In case of fire, there is no restriction on the use of fire
extinguishing material.

A small dust mask must be worn.