12
CLEANING THE GUN AND THE ACCESSORIES
Place the filter inside the gun grip again.
Note:
Place the spring and filter in the correct position.
Apply grease to the tube thread. Assemble in gun.
Note:
Before this, check that the grip locking seal (no. 17 -
figure 1) is in position.
Place the trigger guard in its original position.
ELIMINATING AN OBSTRUCTION
If the spray cap becomes blocked during operation, stop spraying
immediately. Place the gun safety lock. Then operate according to
the following procedure:
Fixed tip
Engage the gun safety. Open the compression valve of the
gun.
Remove the tip guard and nut.
Extract the spray tip.
Remove the obstruction by blowing with compressed air
through the front of the spray cap. Should this prove to be
insufficient, clean the spray tip with the right cleaning solvent
and use the right tip cleaning solvent.
Note:
Do not use metal or sharp objects for cleaning the cap.
Swivel tip
Engage the gun safety.
Turn the lever 180º (no. 1 - figure 8).
Disengage the gun safety, tighten the gun trigger inside the
grounded metal vessel pointing this towards the sides of the
vessel to remove the obstruction. Release the gun trigger.
Note:
The metal vessel used to collect the product must be
correctly grounded.
Engage the safety once more. Turn the lever (no. 1 - figure 8)
again 180º to the spray position.
If the blockage persists, reengage the gun safety. Open the
unit decompression valve.
Loosen the nut which secures the tip. Remove the spray tip.
Remove the obstruction by blowing with compressed air
through the front of the spray tip. Should this prove to be
insufficient, clean the spray tip with the right cleaning solvent.
7
6
5
4
3
1
2
4
3
1
2
7
6
5
FIGURE 8
1
Maximum operating pressure
220 Bar
Dimensions
210 x 130 milimetres
Weight
516 grams
Maximum temperature
72 degrees
Product inlet
1/4” Gas BSP swivel
Product outlet
3.20 milimetres (diffuser head)
Parts in contact with the fluid
Stainless steel, Nylon, Aluminium,
Viton, Tungsten Carbide, Copper
TECHNICAL DATA
