Sage Barista Touch Impress, Руководство пользователя

Страница: 14 / 208

14
the steam wand and insert into milk jug. Lower
steam wand, ensuring it is fully down. The milk
jug should rest on the milk temperature sensor
located on the drip tray and tip of the steam
wand should be submerged and ensure that
milk covers the ring around the steam wand tip.
MAX
MIN
MILK MUST
COVER
THIS RING
NOTE
Check the image on the screen for the correct
milk jug position.
Under the milk jug image, tap the icon to adjust
the milk temperature, the level of milk froth
or change your milk option: Dairy, Almond,
Oat or Soy.
To start, touch the ‘Milk jug’ image. The screen
will display the temperature of the milk as
it heats.
Milk texturing will stop automatically when
the selected milk temperature is reached.
Lift steam wand to remove milk jug. Wipe the
wand and tip with a clean damp cloth. Lower
steam wand to the down position and the wand
will automatically purge.
MANUAL MILK TEXTURING
Auto milk texturing and auto shut-off are
disabled during manual milk texturing mode.
Start with a cold milk. Fill milk jug to below the
spout position. Lift the steam wand and slide the
milk jug under the steam wand. Hold the milk jug
at an angle.
Start frothing by tapping the milk jug image on
screen. When frothing is done and the jug is hot
to comfortably touch; tap the milk jug image on
screen to stop.
Wipe the wand & tip with a clean damp cloth.
Lower steam wand to the down position and
the wand will automatically purge.
CAUTION: BURN HAZARD
Pressurised steam can still be released, even
after machine has been switched off. Children
must always be supervised.
NOTE
• When the machine creates steam, a pumping
noise can be heard. This is the normal operation
of the pump.
• Use exclusively the stainless steel milk jug
included in the pack to froth milk. The use
of container made of glass or plastic material
to froth milk may lead to overheating milk
or dangerous conditions.
USING HOT WATER
The machine has a dedicated hot water spout.
The HOT WATER function can be used to pre-
heat cups or add hot water manually. To start
and stop hot water, touch ‘Hot Water’ icon on
the screen.
Hot water limit is approximately 90 seconds.
Depending on the size of your cup, you may
need to touch the ‘Hot Water’ button to stop
pouring.
NOTE
Using the hot water spout and the steam wand
is not possible when extracting espresso.
Run hot water before or after extracting
espresso.