Step 7:
Extend cable and route through top of tripod. To extend the cable from the unit, pull the
function switch button out, and then pull the crank handle base outward from the 3-Way Housing.
(See Image 15a) This places the 3-way unit into it’s Self Retracting Device configuration. Pull out the
required amount of cable to drop through the head assembly of the tripod. Pulling out once again on
the function switch and pushing the base of the crank handle assembly inward places the unit into
Rescue/Recovery mode.(See Image 15b) Drape the cable over the top of the tripod and slide the
snap hook down through the opening in the top of the tripod where the pulley (previously removed in
Step 4) is normally seated. (See Image 16)
Step 5:
Install the 3-Way onto the tripod by placing the 3-Way onto the pre-installed fixture plate of
the tripod. Seat the hook of the 3-Way bracket plate onto the cross bar of the tripod bracket.
(See Images 5 & 6)
Step 6:
Rotate the winch assembly forward to allow for installation of the locking pin into the
pre-drilled holes in the winch bracket plate and the tripod bracket. (See Images 13 & 14)
Image 11
Image 13
Image 12
Image 14
3-Way Bracket
Plate
Cross Bar of the
Tripod Bracket
Insert Locking
Pin
Hook of 3-Way Bracket
Plate seated onto
crossbar of Tripod Bracket
Tripod Fixture
Plate
Rotate Forward
Winch Bracket
Plate Hook
3-Way
User Manual
V1.0 2020 Copyright SafeWaze
Page 10
