26
8. Slide the Depth Gauge up or down the same distance as the earlier measurement. Use the pencil line
and top of Router Arm as references for measurement and to determine movement of Depth Gauge.
9. Hold the Depth Gauge in position and tighten both bolts.
10. Close top and secure top with bolt.
11. Connect power and air.
12. Make a test cut and confirm Depth Gauge is properly aligned. Readjust if necessary.
Pocket Hole Positioning
Figure 16:
Web dimension, 5/8” minimum
Pocket Hole Location:
Pocket Holes should be positioned at least 5/8” in from end of stock (Web, Fig. 16)) and a minimum of 3/8”
(Offset, Fig. 17) from edge. This provides for a strong joint. Stock wider than 1-
1/4” should have a minimum of
two pocket holes and more pocket holes
if over 3” wide. When joining cabinet sides to a face frame, or other
large panel processing, pocket holes should be spaced every 6-
8” and 2” in from the end (offset).
Figure 17
: Offset dimension, 3/8” minimum
Fence Adjustment
Figure 18: (Web) Fence Adjustment
Fence
Fence Adjustment
Knobs (4)
Fence (Web)
Adjustment Scale
Web
, 5/8” min.
Offset
, 3/8” min.
