SafetySpeed SPM301HD, Руководство пользователя

Страница: 14 / 36

14
INSTALLATION/SET UP
Your SSM Screw Pocket Machine comes from the factory assembled and aligned. You will only need to place the
machine on a level surface and supply power and dust collection and check both the router bit and drill bit. The
included leveling feet allow adjustment to prevent “rocking”.
Tools Required for Installation
Note: Additional tools may be required for installing accessories or making adjustments.
MODEL SPM301:

17mm wrench
– Drill, nut, included

22mm wrench
– Router, collet, included

Spanner wrench
– Router, nut, included

5/32” Hex wrench – Side panels

7/32” Hex wrench – Top lock bolt, included
MODEL SPM301HD

9/16” wrench – Drill, collet, included

3/4” wrench – Drill, nut, included

22mm wrench
– Router, collet, included

Spanner wrench
– Router, nut, included

5/32” Hex wrench – Side panels

7/32” Hex wrench – Top lock bolt, included
Operating Environment
For safe operation, install the machine in an area that is well lit. Eliminate all shadows that could interfere with
clear viewing of the work area.
Do Not locate the machine in a damp or wet location, or a location where it may be exposed to rain.
SSM strongly recommends installing a dust collector with a minimum of 600 CFM to extend motor and bit life.
Avoid explosive atmospheres (gaseous fumes, dust, or flammable materials).
Secure the area so that children and bystanders are kept a safe distance from the work area. Provide barriers
and shields as needed.
NOTE: The average noise level for all the SPM301 models is less than 80 dB.
Initial Set-Up checklist & test:
1. Place machine in desired location.
2. Adjust the four leveling feet (by rotating the feet)
, if necessary, to prevent “rocking” of machine and to make the
machine level.
3. Confirm both the drill bit and router bit are in the correct position by checking with the Bit Gauge (Pgs. 16 & 17,
Fig. 10 & 11). Place the Bit Gauge on the Router Motor Mount or Drill Motor Mount, the bit should just touch
the bottom of the Bit Gauge. If the bits are not positioned properly, follow the
correct “
Installing a Drill/Router
Bit
” instructions to adjust.