safety precaution HTP-T32G, Руководство пользователя

Страница: 31 / 55

H.264 IP Camera Manual
31/4
‰
Serial Port Configuration
z
There is one serial port, RS-485 in HTP-T32G.
The serial ports can be configured as follows.
Each of the serial ports configurations must be same as the connecting device.
Mode Selection
Bitrate
2400, 4800, 9600, 19200, 38400, 57600,
115200 bps
Data Bits 5, 6, 7, 8 bits
Parity NONE, EVEN, ODD bit
Stop Bit 1, 2 bit
‰
PTZ
z
PTZ Type:
Select the type of PTZ camera or receiver.
z
PTZ ID:
Since it is possible to control multiple PTZ cameras or receivers over single control line,
each camera or receiver will be assigned with unique ID. Enter PTZ ID of a camera or receiver
for control. The ID value range can be between 0 and 255.
z
PTZ Port:
Select the serial port used for PTZ camera control.
z
Direct Keyboard Control:
Keyboard controller can be connected to HTP-T32G directly to
control zoom and focus
‰
Sensor Type
There is one sensor input port on HTP-T32G. The sensor port can be configured to the
following.
Function Operation
OFF Not used
NO (Normally
Open)
The port is normally open and activated when
closed.
NC (Normally
Closed)
The port is normally closed and activated
when opened.
The function of the sensor port is set based on the type of the sensor connected.
‰
Sensor Schedule
If you select sensor on, Each sensor port can be enabled or disabled by day(of a week) and hour units.
Sensor is disabled during the grey-colored duration.
REMOTE CONFIGURATION
5. Serial Port configuration
4