SkyCamera
Trailer Installation &
Setup Guide
Important Note:
This guide ONLY applies to van trailers constructed from Duraplate. Intermodal container installs
should reference the Intermodal Installation & Setup Guide. Trailers with sheet & post construction
are not supported by SkyCamera.
Tools you’ll need:
●
Cordless drill (recommended: Power rating of at least 12V)
●
3/16” drill bit
●
1 3/4“ (44mm) hole saw
●
Bracket Placement Spacer (PN 190-0035)
●
Riveter (rated to be able to pop 3/16 stainless steel rivets)
●
5/32" Pin-in-Hex Security Bit
●
Ladder (please follow all OSHA ladder guidelines)
●
Recommended: Safety gloves and protective eyewear
Camera placement:
Camera should be installed on the exterior of the container, left side as you look at the door end. The
top of the bracket should be roughly 3” from the top of the container wall and 18 - 36 inches from the
door end. Ensure that when the door is fully open, it does not pinch the camera.
