39
38
E
.Installing Rear-F
acing
continued on next page.
E-4
Install Rear-Facing with
Vehicle Belts
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Secure LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use
only if the belt is tightened properly and
securely.
Attach the top anchorage hook (tether) to the
recline stand when used rear-facing.
Failure to follow these warnings can result in
serious injury or death.
Store Top Anchorage
Hook (Tether)
Attach the top anchorage
hook (tether) to the recline
stand as shown. Tighten
tether to remove the
slack.
3.
Secure LATCH Belts
You
MUST
store the LATCH
belt hooks to the side of
plastic shell as shown
when using the vehicle
seat belts.
1.
1
2
Fold the recline stand
under the child restraint
2.
43
60-0681
Line to be Level To Ground
Rear-Facing Only
Place Child Restraint in
the Back Seat Rear-
Facing
Move the front seats
forward to give you room to
install the child restraint.
With the child restraint in
the reclined position, center
the child restraint in the
chosen seating position.
4.
Check for Proper
Recline
Make sure level lines on
side of plastic shell are level
with ground. Adjust child
restraint if needed.
You may need to place a
large rolled towel(s) (A) or
foam pool noodle(s) under
the front of the child
restraint to allow the level
line on the side of the plastic
shell to be level with the
ground. Check often to be
sure padding is still in place
and the vehicle belt is tight.
5.
4
360-
0
68
1
Line to be Level To Ground
Rear-Facing Only
Thread Vehicle Belt
Thread the vehicle lap or
lap/shoulder belt
combination through the
rear-facing belt path.
With an ALR vehicle belt,
pull the vehicle belt all the
way out before threading
the child restraint.
6.
436
0-068
1
Line to be Level To Ground
Rear-Facing Only
4
36
0-06
81
Line to be Level To Ground
Rear-Facing Only
A
4358-5258 onSide Air 6/4/10 9:49 AM Page 41
Meijer.com