37
36
E
.Installing Rear-F
acing
4360-0681
Line to be Level To Ground
Rear-Facing Only
436
0-0681
Line to be Level To Ground
Rear-Facing Only
Place Child Restraint in
the Back Seat Rear-
Facing
Move the front seats forward
to give you room to install the
child restraint. With the child
restraint in the reclined
position, center the child
restraint in the chosen
seating position.
5.
4360-06
81
Line to be Level To Ground
Rear-Facing Only
A
Check for Proper Recline
Make sure level lines on side
of plastic shell are level with
ground. Adjust child restraint
if needed.
You may need to place a large
rolled towel(s) (A) or foam pool
noodle(s) under the front of
the child restraint to allow the
level line on the side of the
plastic shell to be level with
the ground. Check often to be
sure padding is still in place
and the LATCH belt is tight.
4.
3.
Hook LATCH to Vehicle
Anchor
Fasten one LATCH belt hook
to the anchor in the vehicle
seat located in the vehicle
seat bight. Repeat for other
side of child restraint.
Check LATCH Belt
Tightness
Grasp the child restraint
at the belt path
with one
hand. Push and pull the
child restraint from side to
side, forward and back. The
child restraint should not
move more than 1 inch.
NOTE:
If it moves more than an inch, try reinstalling the child
restraint or try another seating location.
Secure your child in the child restraint.
7.
To Remove LATCH Belt
From Vehicle Anchor
Remove child from child
restraint. Press down
firmly on adjuster side of
child restraint and press
release button to release
tension. Unhook LATCH
from bar by squeezing
spring lever and twist hook.
8.
Tighten LATCH Belt
Push down firmly on the
child restraint and pull up
on the free end of LATCH
belt to tighten.
6.
It maybe easier to tighten
the LATCH belt through the
belt path opening as
shown.
4358-5258 onSide Air 6/4/10 9:49 AM Page 39
Meijer.com