51
52
Lap Belt
Lap/Shoulder Belt
E-5
Rear-Facing Installation without Base
E
.Installing Rear-F
acing
Never place a child rear-facing in a
seating position with an active frontal
airbag. This can result in serious injury
or death.
This child restraint must always face the rear
of the vehicle when the child is between 4-35
lbs (1.8-15.9 kg) and is less than one year old.
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Store LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
Thread Vehicle Belt
Thread vehicle lap belt
through the belt path (as
shown). Buckle the
vehicle belt.
With an ALR belt, pull the
belt all the way out before
threading.
2.
Tighten Vehicle Belt
Lay your forearm across
child restraint at the belt
path while pulling up on
belt to tighten. Feed the
slack back into the
retractor while tightening.
3.
Place Child Restraint in
Vehicle Rear-Facing
Center the base in the
chosen seating position.
Check the angle indicator.
The ball should be
between the two marks
on the indicator that
matches the weight of
your child.
NOTE:
Check the angle
indicator while parked on
level ground.
1.
E-6
Installing Carrier with
Vehicle Belts
4358-5480 US S1 onBoard Air 10/1/10 10:27 AM Page 53