11
12
Check your child’s fit often.
If you cannot achieve a snug harness fit for your child,
see
pages 12-15.
To learn how to check harness tightness,
see pages 54-56.
Insert Buckle’s Metal
Retainer into Buckle
Slot Closest to Child
The buckle
must
face out.
Rear-Facing Mode
: You
must
use
the
1st or 2nd
buckle slot.
Forward-Facing Mode
:
Any
slot can
be used.
Pull Metal Retainer Completely
Through Pad and Shell
Check Buckle
Pull up on the buckle to make sure
it is secured.
The buckle
must not
pull out.
5
6
7
Failure to place buckle’s metal retainer completely
through pad and shell can result in serious injury or death.
continued on next page
Harness System Adjustments for
Smaller Infants
With Buckle in 1st Slot,
Release Seat Pad’s Elastic
Straps and Pull Up Front of Car
Seat Pad
To remove the front of the pad, see
page 65.
If you need to move the buckle to the
1st slot, see pages 10-11.
Reach Between Shell and Base,
Pull Metal Retainer Down and
Push It Up into Middle Slot
As Shown
If you cannot achieve a snug harness fi t for your child,
you may need to adjust the buckle strap and
harness strap length as shown in this section.
1
2
Adjusting Buckle Strap
From Top of Car Seat, Lay Metal
Retainer Flat Against Shell As
Shown
3