SAFETRACK ST.33, Руководство пользователя

Страница: 11 / 22

11
TURNING MACHINE ON AND OFF
THE CONTROL PANEL
The control panel on your battery rail drilling machine is designed for maximum operating facility and
safety.
1 - The ON Switch (GREEN):
This (upper) switch is used to switch the motor unit On (“I“);
2 – The OFF Switch (RED)
This (lower) switch is used to switch the motor unit Off (“O“);
3 - The Main power Switch (WHITE):
This switch is used to turn on the main power. The indicator has two collors:
•
GREEN – SAFE for use
•
Alternately lightning up RED and GREEN and making a beeping sound – Not safe for use.
In order to operate properly, the machine has to be turned on following the procedure as described
below.
DRILLING A HOLE
Now that you have read the explanatory information and safety recommendations above, you are ready to
actually start drilling. Follow these steps for best drilling result:
1 Use the tip of the pilot pin to determine the center of the hole to be drilled.
2 Fasten the clamp on and verify that the drill is in the right position and that the machine is pushed
tight against the rail.
3 If your machine is equipped with an auto coolant system, open the valve to release the oil. If your
machine does not have an auto coolant system, fill the holes of the spindle with oil.
4 Turn the motor on at the highest setting and allow it to run at full speed.
5 Turn the arms to start drilling. Apply only a slight pressure when the Annular Cutter touch the metal.
Do not push the TCT Cutter with force into the metal.
6 Apply a regular pressure while drilling. The drilling performance does not improve by putting more
pressure on the feed handles. Too much pressure will overload the motor and your Annular Cutter will
break or will worn sooner.
Let the cutter do the job and give it time to cut the metal!!!
7 Adjust the oil supply when necessary, if your drill does not have an auto coolant system, stop drilling
regularly, refill the holes of the spindle and continue drilling.
8 Apply less pressure when the drill cuts through the material.
9 Turn the arms to put the motor in highest position and turn off the motor unit.
10 Remove the burr, metal chips and clean the cutter and surface without getting injuries.
Caution : The metal piece drilled out can be sharp and very hot!!
DRILLING WITH TCT CUTTERS
TCT cutters only cut material at the periphery of the hole, rather than converting the entire hole to
shavings. As a result, the energy required to make a hole is lower than for a twist drill.
When drilling with an TCT cutter, it is not necessary to drill a pilot hole.
WARNING: Do not touch the cutter or the parts close to the cutter immediately after operation, as
they may be extremely hot and cause burns to the skin. Ensure nobody is in the work area where the
metal core is ejected.