SAFEMATIC MAXILUBE IF-105, Руководство пользователя

Страница: 6 / 11

MAXILUBE
IF-105
MUIF3AEN.doc 21.4.2005 Rev. 3A
5 (9)
3.1.3 Normal mode displays
Normal mode displays, which show lubrication program set values, can be browsed with
Ï
-button.
Display codes change in the following order when
Ï
-button is pressed.
Display code Description
CH The lubrication channel selected on the display. Code is used only
in a system with two channels. Press
SET -button to move to
another channel when the code is displayed.
(
Ch annel)
Cou Lubrication cycle counter
(Cycle
Cou nter)
C
Lubrication cycle set value [h.mm]
(Lubrication
C ycle)
P Maximum pressurization time set value [s]
(Lubrication,
P ressurization time)
Set value can be changed to minutes with factory setting parameter
Prt.
PLo Low limit pressure set value [bar/psi]
(
P ressure, Lo w limit)
Code is used only in pressure transmitter operation.
PHi High limit pressure set value [bar/psi]
(
P ressure, Hi gh limit)
Code is used only in pressure transmitter operation.
dEL Pressure discharge delay multiplier [n]
(
DEL ay) Delay = P * n [s]
Code is used only in pressure switch operation.
HL Manual operation setting
On : manual operation mode
OFF : automatic operation mode
Decimal points are used to separate thousands in lubrication cycle counter reading. Counter
max. reading is
49.9 = 49 999.
According to lubrication system basic settings pressure unit on the display is bar or psi. In psi –
reading decimal points are used to separate thousands. For example
1.02 = 1020 psi.
3.1.4 Line pressure displays
Pressure transmitter operation
In pressure transmitter operation, line pressure displays can be selected with
Î
-button.
Pressing the button will show the line 1 pressure display first. Code P1 and line 1 pressure
display are displayed in turns. Pressing the button again will show the line 2 pressure display.
Code
P2 and line 2 pressure display are displayed in turns. If line 2 does not exist, program
returns to display the phase code. From line 2 pressure display program returns to display
phase code by pressing
Î
- button. The display returns to display the phase code automatically
after 4 minutes if the buttons have not been used.
If signal from pressure transmitter is not detected code _ _ _ is displayed.