© Safe Fleet | May 2018 | All rights reserved | Part #: 700-1111 R2
Title of Document
p. 22
Performing AVM Calibration
Tuning Cameras
Once you’re done with calibrating the individual cameras, you’re ready to move on to the next step. Here you’ll tune each
individual camera to ensure that you’re getting the optimal view on the in-cab monitor.
1. Go to the
Left-Right Tuning
screen.
2. Click
Input Image
to load your recently calibrated images. Select the
Output
folder and click
Select Folder
.
3. Using the tuning buttons, adjust the left and right camera images to get the optimal view.
a.
Roll
rotates the camera image clockwise or counter-clockwise
b.
W-Scale
stretches the camera image vertically
c.
H-Scale
stretches the camera image horizontally
d.
Trans. H.
slides the camera image left or right
e.
Trans. V.
slides the camera image up or down.
4. After you’ve tuned both Left and Right cameras, click
Apply
, then
Save
.
5. Move on to the next tab,
Front-Rear Tuning
.
6.
Repeat
the same procedure for tuning the Front and Rear cameras. Once complete, click
Apply
and
Save
, then move
onto the last screen,
Parking Guide Lines
.
Note:
Viewing
Tuned
Images
Once calibration is complete, the tuned images will appear on the in-cab monitor in both NT and ST modes. The driver
can switch between each individual camera view by using the AVM push button installed on the dash.
