Saey Fenix 60 Optic, Руководство по эксплуатации

Страница: 17 / 28

S
AEY
FENIX / SAEY FENIX VITRO
810.6011.000 / 02
69
English
9.4 Stoken met brandhout
For the appliance to reach the desired temperature quickly without too many undesirable
emissions, after lighting you should follow the following heating procedure:
Put 2 or 3 ‘not too big’ blocks in the insert, on top of this you place some kindling and little pieces of
wood, together with a few firelighter. Open the air inlet maximal. And set the vaentilator in position
II to have an easy start. Close the fire door ! When the wood is burning well, the desired position
of the air inlet can be chosen.
Wood burns for a long time and produces a lot of gas; it must be burnt fast with a constant oxygen
supply. To reduce the possible undesirable effects of long-term reduced air supply, it is best to let
the stove burn for a quarter of an hour at full power every day that it is used.
Possible undesirable effects:

Smouldering fire, condensation, tar deposits

High levels of soot

Smoke problems (emissions of poisonous substances)

Risk of explosion
Wood is not suitable for a small fire! In other words, a wood-
burning stove can’t be damped down.
It can take a long time to burn down fully. This means that, when the air inlet is closed, the set
temperature is only reached when the wood is burnt well down and the degassing process
–
whereby the large flames die back and only the glowing embers of the wood remain
– is complete!
In particular, avoid adding excessive fuel, otherwise too much heat is released, a lot of combustion
gases are released and the appliance will be overloaded.
9.5 Possible settings
The stove has a higher output when the door is closed. In this way it produces heat in completely
safety by radiation and convection.
We can choose from 3 possible settings.
A. Very high convection and radiation heat emission.
High wood consumption.
Open the primary air inlet completely to obtain a keen and fast flame. This setting should be
used only to light the fire. Once the stove is hot, select another position (see B or C).
B. Very high convection and radiation heat, moderate wood consumption with minimum pollution
and maximum output. Gradually close the air regulator to maintain a good flame without
burning intensely. At this setting a fully loaded appliance should be able to burn all night and
still give off good convection heat. Using extremely dry wood and an appropriate flue draught,
the window will stay clean for longer.
C. Average convection and radiation heat - low wood consumption. Close the air regulator until
the flame almost extinguishes. In this way the stove will burn all night (depending on the flue
draught) but the window will become dirty because combustion is not complete.