Right before brewing coffee, fill the
container with freshly ground coffee.
For best results, make sure coffee
blend is fresh. Remember that ground coffee
ages soon, thus losing its quality!
35
Important!
Use the measuring spoon supplied to fill the
container (14) with a single portion of ground
coffee! Use a full measure only.
To dispense coffee, press pre-ground coffee
button and the desired selection key (large
coffee, coffee, small coffee] to obtain a cup of
coffee.
Important!
This function does not allow the
double coffee cycle.
Dispensing may be interrupted by pressing one
of the coffee selection keys, if an excessive water
amount has been selected.
Hot water dispensing
Hot water dispensing is accomplished through an
independent water circuit which ensures the
correct temperature and supplies tasteless hot
water to be used for tea, soup, etc.
By operating the hot water key, the following two
messages will be displayed:
To program the hot water amount, it is necessary
to keep the corresponding selection key pressed
till the desired amount is reached.
Attention: hot water can only be programmed
if the corresponding programming function is
enabled (see page 76).
During the programming phase, the following
message will be displayed:
36
Place a glass or cup under the steam/hot
water spout (7), then press the hot water section
key. Hot water will be automatically dispensed.
Steam dispensing
To heat milk or other drinks.
Always clean the spout with a
damp cloth soon after the use;
otherwise, it might be difficult to
remove milk residues.
After a steam outflow, always drain the machine.
By turning steam knob (9), these
two messages will be displayed:
This happens because the machine, as men-
tioned before, can dispense two products at the
same time.
During hot water dispensing, only the pro-
grammed amount is dispensed if the correspond-
ing programming is enabled. On the contrary,
dispensing should be stopped by pressing again
the selection key when the desired amount is
reached.
If hot water only is dispensed, dispensing is
raster than when coffee is dispensed at the same
time.
This happens because the machine, as men-
tioned before, can dispense two products at the
same time.
Direct steam/hot water spout (7) on cup holder
grill |3) and slightly open knob (9), turning it
counterclockwise.
Wait until the remaining water has flown out of
the spout. Then, move the spout outwards and
plunge it deeply into the fluid to be heated.
Slowly open the steam/hot water knob and
heat the fluid, with a circular movement from the
bottom to the top.
81
BREWING
HOT WATER
PROGR. QUANTITY
HOT WATER
READY FOR USE
STEAM
READY FOR USE
SELECT PRODUCT
READY FOR USE
SELECT PRODUCT
READY FOR USE
