English
26
To program price 1, press the DOWN button. The display will show 001. Press the
ENTER button to display and modify the price 1 value.
Follow the same procedure to modify price 2, if desired.
To set the value to 000, press the CLEAR button. Should the machine be programmed
to have two different prices, price 1 should always be lower than or equal to price
2.
If a few products will be dispensed free-of-charge and others will have prices,
program by assigning a free-vend value 000 to price 1 and the required payment
value to price 2 ; then use the machine programmer to assign price 1 to the free-of-
charge products.
To program the machine to have one price only, enter the same value for both price
1 and price 2, then use the machine programmer to program all the products to have
Fig. 18
either price 1 or price 2. The machine will automatically set both price 1 and price 2 to 000; therefore, if the two values are not changed,
the machine will continue to dispense only free-of-charge products.
Price “2” programming example
• Press the UP button. The message 000 is displayed.
• Press the UP button twice. The display will show the menu 2 (price 2).
• Press the ENTER button. The display will show 000.
• Press the UP button. The display will show the lowest possible setting.
• Press the UP button until the required value is reached (e.g. 800).
• Press the ENTER button to save the value. The display will show menu 2 again.
• Press the CLEAR button to go back to the initial menu.
• Press ENTER to quit the programming mode.
To assign the beverage price, use the 7P Programmer.
Programming the coin value
The coin value must be changed according to the coiner programming.
Set the values relevant to each coin recognised by the coiner (see the table on the coiner), according to the limits set forth on the
label of the nation key envelope. To program values, follow the procedure below :
• From the 000 menu, press the UP button to move to the A-1 menu.
• Press the ENTER button to display and modify the value of the coin accepted by coiner channel 1.
• By pressing the UP button, the displayed value is increased; it is decreased by pressing the DOWN button.
• After having set the required value, press ENTER to confirm. The value is stored and A-1 is automatically displayed again.
• In order to program the channel 2 coin value, press the UP button; the display will show A-2.
• Press ENTER to display and modify the value of the coin accepted by channel 2.
• The CLEAR button may be pressed to set the value to the smallest coin accepted by the coiner. The equipment is pre-set to the
coin values shown on the coiner data plate. Tokens are assigned a value which is equal to that of the smallest coin accepted by
the coiner.
The RS 232 male serial connector (30) is used to operate SAECO CARD only.
☞
UP button
DOWN button
CLEAR button
ENTER button
COINS ACCEPTED
CAPPUCCINO
LONG
ESPRESSO
ESPRESSO WITH
A DASH OF MILK
ESPRESSO
