3.4 Battery mold rack assembly:
3.4.1 First, fix the bottom of the unit mold on the base.
3.4.2 Using the positioning pins to fix position when installation. Use two locating pins calibration two pairs of
diagonally arranged holes in 4 holes. After adjusting the relative position of unit mold and base, putting the
bolts into the other two holes to both fixed. Then out of the positioning pin, and insert the bolt fixed.
3.4.3 Followed by installation of several units above mold, the installation method is the same with and unit mold
and the base
Align the upper
surface
Opening toward the
front side
Positioning
pin to fix
position