CHS100.86.011 Rev.02 Date 23/07/2018
21
Diameter of the spacing starwheel:
enter the dimension for the diameter of the spacing
starwheel, expressed in millimeters.
Diameter of the spacing roller:
enter the dimension for the diameter of one of the spacing
rollers, expressed in millimeters.
Conveyor motor M15/M25 rated speed:
enter the number of rated revs/min, referred to
the cap conveyor motor.
Motor M15/M25 conveyor gearbox
: enter the value of the reduction ratio for the gearbox
referred to the cap conveyor.
Inverter M15/M25 maximum frequency:
enter the maximum frequency value for the
inverter in the cap conveyor.
Type of cap diverter (0=deactivated, 1=std, 2=side)
: enter 0 if the cap diverter is not
provided, 1 to activate the configuration of a standard diverter and 2 to activate the
configuration of a side diverter.
Overturned cap control with starwheel (0=not present, 1=present)
: enter either 0 or 1 if
the overturned cap control is not present or present respectively.
Camera on spacing starwheel (0=not present, 1=present):
enter either 0 or 1 if an image
capture station is not present or present on the starwheel timing device. This setting
activates photocell SQ53b for CHS100.
Enable Spark Tester (0=disabled, 1=enabled):
enter 0 and 1 to disable or enable the
signal exchange between PLC and Spark Tester.
Production speed minimum limit:
type in the value for the minimum level of production
speed to which the machine can be set.
Production speed maximum limit:
type in the value for the maximum level of production
speed to which the machine can be set.
Feedback presence U25 (0=absent 1=present):
enter 0 if the Inverter U25 ready signal
(READY U25) is absent, and 1 if it is present. This signal is displayed on the page I/O CH2
11- READY U25.
Reject boxes presence check enabling (0=disabled 1=enabled):
enter 0 to disable the
reject boxes present check, and 1 to enable it. When enabled the sensors SQ9A/B/C/D must
be used.
CHS infeed closures total counter
: displays the total number of caps fed into the machine.
To reset this counter, press the corresponding RESET button.
CHS outfeed closures total counter
: displays the total number of caps fed out of the
machine. To reset this counter, press the corresponding RESET button.
