SAC ROTO-PRESS 1095, Руководство оператора и каталог запасных частей

Страница: 18 / 54

Page # 18
5.) Put the bag around and under bottom of the shroud. And be sure to put the bag on so
that the bottom bag folds come off fi rst. Then winch the bag lift up and move trolley\bag lift
back over shroud. (Figure 4)
Caution: Do not over tighten bag lift cable as to bow bag lift ends. Be careful not to
pinch the bag.
ROPE
BUNGEE CORD
6.) Being careful not to cut the bag, cut the remaining straps and remove them. Carefully
pull the inside layer of the bag off . A gentle tugging action works well. Make sure you don’t
pull the rest of the bag off the bag lift. Pull the bag off to 6 feet behind the machine. With
one person on each side, pull the main part of the bag out and forward on the apron. This
will get the wrinkles out and avoid getting the bag caught between the bag apron and the
machine.
7.) Raise the bag apron up. Put the bungee cord over the bag just behind the main bag yet
ahead of the tube. Place ropes with the bottom side of the bag apron and the hook into the
holes in the front tube (keep the hook to the outside so it does not catch on the bag) about
half way up to begin. (Figure 6) Do the same on both sides. The cord must be tight and
go on the front side of the apron. This is very important. Tie the ropes on the bungee cord
forward to their appropriate hook.
8.) Now to close the bag, pull enough off of the shroud so that you can close off the one
end. Pull a little more off of the bottom to start out. It is important not to allow wrinkles
and to keep the bag fold lines straight. Take the opening of the bag and fold in both sides
to form a pleat. Also requires the use of (2) 10’ 2 x 4’s. (Figure 3) Place the blank board on
top and roll the bag around it four (4) times. Place the pre-nailed board on top to sandwich
the plastic and nail them together.
USING YOUR ROTO-PRESS