Service Engine - 25
SERVICE ENGINE
11.Run engine at idle for 30 seconds. Stop engine. Wait 30
seconds and check oil level.
12.If necessary, add oil to bring level to FULL mark on
dipstick. DO NOT OVERFILL.
Changing Engine Oil and Filter (107-17 HS)
1. Run engine to warm oil.
2. Park tractor on level surface. STOP engine. LOCK park
brake and remove key.
3. Lift hood.
4. Put drain pan under drain valve.
5. Unsnap the dust cap, push and twist to open oil drain
(A) and drain oil into oil drain pan.
6. Close drain cap.
7. Remove old filter (C) and wipe off filter tray with a clean
cloth.
8. Lightly oil filter gasket with fresh, clean oil.
9. Install replacement oil filter. Turn oil filter to the right
(clockwise) until rubber gasket contacts filter adapter.
Tighten filter an additional one-half turn.
10.Remove dipstick (B) and refill with new oil of
recommended grade. (See Engine Oil in this section.)
11.Check oil level. For correct procedure see Checking Oil
Level in this section.
12.Oil level must be between ADD and FULL marks. Do not
overfill.
13.Install and tighten dipstick. Lower hood.
14.Start engine and check for oil leaks. Correct any leaks
before operating.
15.Run engine at idle for 30 seconds. Stop engine. Wait 30
seconds and check oil level.
16.If necessary, add oil to bring level to FULL mark on
dipstick.
Checking and Cleaning Air Cleaner Elements
NOTE: It may be necessary to check the air filter more
frequently if operating vehicle in dusty conditions.
c
CAUTION: Avoid injury! Engine may be hot, be
careful not to burn hands.
IMPORTANT: Avoid damage! To extend engine life,
when operating mower in extreme heat, dust or
other severe conditions, it may be necessary to
change engine oil and filter more frequently.
A
M96093
B
A
C
Содержание 97-14 HS
Страница 66: ...Notes NOTES Notes ...