Sabo 36-EL, Руководство оператора

Страница: 61 / 98

13
GB
If the lawn has to be mowed in a very damp, wet state, the cut grass must be shorter i.e. the cutting height must be set 1-2
levels higher than with a dry lawn.
You will notice that if you follow these simple rules you will have a healthy lawn and can save on disposing of your grass
cuttings.
If the grass should happen to be too high for mulching, the mulching mower can be converted for mowing with a grass
collecting bag in no time.
Converting the machine to rear ejection (Illustration U2 + S1 )
– Stop the engine.
– Lift up the ejection flap.
– Remove the mulch stopper from the duct
U2 .
– Hang the grass collection bag in the provided holder on the mower housing S1 .
Conversion of the mulch blade system is not required! Under difficult mowing conditions (e.g. wet grass) a reduced filling
level of the collection bag can result.
In order for the equipment be used once again as muIch mower, the muIch stopper must be installed again. To do this,
remove the grass collection bag, introduce the muIch stopper in the ejection duct and close the ejection flap.
14 SERVICE INTERVALS
IMPORTANT
Avoid damage! Under extreme or unusual conditions, shorter servicing intervals than the ones specified below may
be necessary. If you establish any problems, please contact an authorised workshop.
Carry out routine servicing on the machine in line with the following servicing intervals.
Work must be carried out at the following servicing intervals in addition to the maintenance work listed in these operating
instructions.
Before initial use
• Check all screw connections for a tight fit.
• Check the cutting blade screw and have an authorised workshop tighten it if necessary.
• Check whether the safety control bar for the engine brake is working perfectly.
• Check that all protective devices have been attached properly and are not damaged.
Before every operation
• Check the lawn area and remove any objects.
• Check the area of the boundary wires (if an auto mower is being used for lawn care).
• Check the condition and firm fit of the blade, if necessary have an authorised workshop tighten the blade screw.
• Check whether the safety control bar for the engine brake is working perfectly.
• Check that all protective devices have been attached properly and are not damaged.
• Check grass collecting equipment for wear or loss of functionality.
• Check the upper part of the bar (insulation) for damage.
• Check the connection cable for damage and ageing.
Every 10 operating hours
• Check all screw connections for a tight fit.
• Check the fan, blade coupling and fan housing regularly for wear and a tight fit.
After every operation
• Clean the mower.
• Check the blade for damage and wear.
Every 50 operating hours or once a year
• Lubricate the wheel bearings.