Sabo 36-EL, Руководство оператора, Страница: 56 / 98

8
GB
6 DESCRIPTION OF COMPONENTS
1 Actuating grip for motor (safety grip)
2 Cable connection plug
3 Ejection
flap
4 Electric motor
5 Handle for adjusting the height
6 Motor
bracket
7 Cutting height indicator
8 Carrying handle front
9 Strain relief device for electric cable
10 Cable
guide
11 Casing on the upper part of the bar
12 Locking button (red)
7 PREPARATION
The following parts are included in the packaging for assembly of the mower:
•
Mower with preassembled handle
• Collecting bag, collecting bag frame, chute
• Tool bag with the following contents:
– Operator's manual with Declaration of Conformity
– Warranty conditions and Warranty card
– Various fixing parts.
In the unlikely event of a missing part, please contact your dealer.
Opening out the handle (Illustration A1 + E1 + B1 )
– Pull the folded-up Z-shaped guide spar apart and upward A1 .
– When upper and lower handle are aligned tighten the two wing-nuts by hand E1 .
– Push both ends of the bottom part of the handle with the toothed plastic adapters backwards until they click into the
toothed recess on the mower housing B1 .
In this way, three different handle heights can be set.
– Tighten the two wing-nuts on both sides by hand B1 .
– Insert the cable into the cable guide. This is to prevent the cable from being trapped when folding the handle E1 .
– Fasten the cable to the lower part of the handle with the aid of cable ties from the tool bag. When folding the upper
handlebar section, ensure that the cable is not trapped.
CAUTION
When you activate the bar height adjustment, when loosening the wing nuts B1 used to secure the bar bottom to
the housing (only loosen sufficiently to ensure that the bar can be moved freely) and snapping the toothed plastic
adaptations from the cut-out on the housing, it is possible that unintentional upsetting of the bar may occur. In
addition, this may result in crushed points between the bar bottom and the housing. This may result in a risk of
injury!
Assemble the collecting sack and hang it onto the mower (Illustration Q1 + R1 + S1 )
– Remove the attached fixing panels from the chute Q1 .
– Set the chute into the collecting bag frame at an angle. By moving the chute down press the holding bracket on either
side onto the collecting bag frame Q1 .
– Then press the lower holding brackets of the chute onto the transverse rod of the collecting bag frame.
– Screw the two fixing panels to the chute again
R1 .
– First insert the grass bag frame with the clip forward into the grass bag. Align the upper seams of the bag with the clip.
– Press the retaining profiles of the collecting sack onto the bars of the collecting sack frame
R1 .
– Open the ejection flap of the mower upwards.
– Pick up the collecting sack by the carrying strap, place the chute (1) at the collecting sack opening into the ejection flap
and hang it in the mower casing with its two side hooks upwards S1 .
– Attach ejection flap to collector.