8 32 026 006
Saab 9-5
23
5D -
Route the wiring harness out and plug in
the connector:
·
Remove the left-hand mounting bracket (A)
for the bumper under the left-hand tail lamp.
·
Remove the cable tie (D) and tape from the
rubber grommet below the left-hand tail lamp.
·
Pull the wiring harness out through the rubber
grommet until the grommet is 370 mm from
the end of the cable terminal taping.
·
Insert the cable terminals (C) as follows:
1 Black (BK)
2 Brown (BN)
3 Yellow (YE)
4 Blue (BU)
5 Orange (OG)
6 Grey (GY)
·
Affix tape and fit a new cable tie (B) on the
rubber grommet.
·
Fit the left-hand mounting bracket (A) for the
bumper shell under the left-hand tail lamp.
The wiring harness must be routed inside the
bracket (D).
Important
Check that the cable terminals lock firmly and that
the whole of the seal is in contact against the con-
nector.
Be careful so that the seals are not damaged.
A
D
B
C
A
E930A520
