6 32 026 006
Saab 9-5
10
5D:
Remove the moulding (4 screws) from the
bumper shell.
11 Remove the bumper rail (A) from the protective
shell by detaching the retaining clips.
12 Remove the cellular block (B) from the bumper
shell (wedged into the protective shell's mount-
ing wedges).
13 Drill 4 x 31 mm holes (C) in the pre-punched
markings in the bumper shell.
14 File out the guide groove 1 x 1 mm (C). The
guide groove must be on the side of the hole fac-
ing the left-hand side of the bumper shell.
15 Fit the distance sensors (D) in the holders (E)
and then in the bumper shell.
16 Pre-route the wiring harness in the centre foam
section (F). The connector comes out on the
left-hand side. Connect the wiring harness to the
sensors.
17 Fit the connector holder to the left-hand side of
the bumper rail and fit the connector into the
holder (G).
18 Fit the cellular block (B) with wiring harness in
the bumper shell.
19 Guide the bumper rail (A) in toward the bumper
shell's guide pin. Fit the bumper rail with any
reinforcements to the bumper shell.
20 Fit the remaining cellular blocks.
21
5D:
Fit the moulding (4 screws) to the bumper
shell.
Important
Do not file too far! The cover would then not be
over the guide.
WARNING
Check that the wiring harness is not trapped.
Incorrect fitting could damage the wiring harness
and cause a short-circuit/fire.
E930A518
C
G
F
D
E
A
B
