S-WORKS Specialized Shiv TT, Инструкция по эксплуатации

Страница: 8 / 24

Page 6 of 20
CHAPTER 1: HANDLEBAR / STEM INSTALLATION
1.1 INSTALLING THE CABLES IN THE HANDLEBAR
35cm 150cm
1. Cut the front brake cable housing (1-A) to 35cm length. The final housing length may need to be trimmed, based on the brand of brake levers (fig.3).
2. Cut the rear brake cable housing (1-B) to 150cm length. The final housing length will be to be trimmed during the rear brake installation.
3. Run the front brake cable (1-C) backward inside the front brake cable housing.
4. Install the front cable housing, from the underside of the handlebar (1-D) through the center hole, by first running the brake cable through the
handlebar, then pushing the cable housing through. The cable can be used to help pull the housing through as well.
5. Repeat for the rear cable housing, but through the top of the center hole of the handlebar.
6. Make sure the cable housings stick out at the brake lever end by about 2” to engage the cable housing slot in the brake lever.
7. Once the housings are installed in the handlebar, remove the front and rear brake cables from inside the cable housings.
1
1-D
1-B 1-C 1-A
2
Front
Rear