S-WORKS Specialized Shiv TT, Инструкция по эксплуатации

Страница: 17 / 24

Page 15 of 20
CHAPTER 3: HANDLEBAR EXTENSION INSTALLATION
In addition to frame size options (different reach), the Shiv TT handlebar assembly is adjustable vertically (stack adjustment) and horizontally (reach
adjustment).
The stack is vertically adjustable (not in line with the steerer tube), so that stack height adjustments do not affect the reach of the bicycle.
Stack height can be configured with the following options:
„
Extensions with no risers, with or without spacers (0-40mm in 5mm increments)
„
Extensions with risers, with or without spacers (45 to 115mm in 5mm increments. Maximum of 75mm of risers and 40mm of spacers)
Additionally, the pad holders can be configured with the following options:
„
Laterally from the center position by +/- 14mm, for a total width adjustment of 28mm.
„ Fore-aft, in either a forward or rearward setting, for a total reach adjustment of 22mm.
The lateral extension width with no risers is 80mm.
The lateral extension width with risers and crossbar is 110mm, due to the crossbar mounting holes being set further away from center.
WARNING! Be sure to select the appropriate bolt length to match the desired risers and/or spacers at each point, as shown in the
accompanying tables. Incorrect bolt lengths can result in failure, which may lead to serious personal injury or death.
3.1 INSTALLING THE AERO EXTENSIONS (Option 1 - no risers, with our without spacers)
5mm
5
15mm
5
10
20mm
20
10mm
10
25mm
5
20
30mm
10
20
35mm
5
10
20
5
5
10
20
40mm
A
A
A
A
1. Grease then install 4 bolts (A). Bolt length varies according to desired spacers (5-40mm in 5mm increments), if any (Table Option 1).
2. Torque the bolts to 80 in-lbf (9.0 N*m).
Extensions (3-A) and spacers (3-B) are specific to left and right sides. Make sure the spacers’ curves fit the extensions and handlebar
or wing correctly.
Lateral extension width is set at 80mm when only using extensions (no risers) with or without spacers (see fig.4).
3. If more than 40mm of stack height is required, refer to page 16 (fig.2) and page 17 (fig.3).
1
OPTION 1:
Bolts (A) into Extensions,
with or without spacers,
no risers
Spacer
Height
Bolt
Length
0 25
5 30
10 35
15 40
20 45
25 50
30 55
35 60
40 65
3-A
3-B