S-WORKS Specialized Shiv TT, Инструкция по эксплуатации

Страница: 16 / 24

Page 14 of 20
6. Adjust the angle and height of the brake pads against the rim, same as the front brake (fig.5 & 9).
7. Tighten the brake pad bolts (fig.9).
NOTE: The rear drive-side brake pad bolt requires a 10mm wrench to tighten.
8. Run the cable through the noodle and loop it around the pinch bolt.
9.
Adjust the clearance between the rim and the pads to approximately 1mm on each side (fig.9).
10. Torque the cable pinch bolt to 55 in-lbf (6.2 N*m).
1-2mm 1mm
11.
Adjust the spring tension screws with a 2mm Allen key to center the brake pads relative to the rim.
12. Make sure the spring tension screws are inset enough so that the drive side clears the chainring.
8
9