S.R.Smith Power Tower PT-6002, Руководство по установке

Страница: 12 / 12

12
WARRANTY INFORMATION
For Lighting product warranty information and details, please visit our website:
www.srsmith.com/warranty
S.R.Smith, LLC
800.824.4387
srsmith.com
© 2019 S.R.Smith. All rights reserved. 79-15281-00 08/19
Questions?
Contact One of Our Dedicated Lighting Specialists.
1-800-824-4387
x4012 or x2282
Instrucciones de instalación disponibles en español en www.srsmith.com.
T R O U B L E S H O O T I N G
The remote function of this device operates through radio frequency (RF) signals. As with any RF device,
this is subject to interference through surroundings and installation location. In the event of an interference
issue or if longer range is required, the internally mounted antennae may be removed and an accessory
antenna kit may be used to extend the RF antenna towards the use area by either a 3 meter or 15 meter
extended cord and magnetic mounting base. Like any radio device, experimentation may be required
to locate the best reception spot. To install the pLX-ANTKT-S or pLX-ANTKT-L, please disregard the
instructions included with the kits and follow these steps as outlined below:
1. Shut off power at the appropriate circuit breaker; remove all chances of accidental electrical shock.
2. Remove lift-off cover to allow access inside the PT-6002.
3. Find the 5cm antenna directly connected to the SMA jack on the receiver board, inside the black receiver
enclosure. It will be next to the 4 place, DIP switch selector. Carefully unscrew the antenna from the
SMA jack.
4. Find a suitable mounting location within the cord range of accessory antenna kit. Use the screws
included with the kit to mount the metal bracket on a wall or appropriate surface. Place magnetic base
of the antenna on the metal bracket. NOTE – when mounted, the antenna should be in the vertical
orientation. Often times, simply moving the antennae up on a taller location will greatly improve
reception.
5. Bring the screw-on SMA connector back through the Left or Right round ventilation openings in the
chassis and carefully thread the connector on the SMA jack on the receiver board. Make sure there is
enough slack that the cover may be reinstalled and the cable is able to pass through the bottom of the
ventilation opening on the lift off cover.
6. Once everything is reconnected and the cover is reinstalled, restore power from the circuit breaker and
test the remote function.