700-1000 - B
June - 2010
6
Battery –
The battery is located on top of the Control Box and is removable. It should be
charged daily. Do not allow battery to fully discharge, as it will shorten battery life. Whenever
battery is removed from Control Box or lift is not in use it is important to connect battery to
charger. This ensures battery is fully charged and ready for use. The LCD indicator on the
battery can be checked to determine the battery charge level.
Do not drop battery as it could cause the unit to fail. If battery case is cracked do not use and
replace. Do not place battery on a conductive surface. Placing battery on a conductive surface
may cause a short. Battery has contacts located on bottom of housing. During temperature extremes
beyond the range of
41 F (5 C)
to 104 F (40 C) remove battery and place in a controlled environment or
battery life can be shortened.
Console/Battery Cover –
Keep the Console/Battery Cover installed at all times to prevent moisture from
collecting on the Control Box and battery. Excessive moisture collection can affect battery and lift
performance and could lead to battery failure and/or the lift failing to operate. Whenever the battery is
removed for charging the Console/Battery Cover must be placed over the Control Box to protect the unit
from the elements.
Hand Control -
The four button unit controls all lift movements. The arrows indicate
direction of movement. Control is fully waterproof and meets IP67 standards.
Mast -
This vertical piece is bolted to the base assembly.
Actuator -
Attached to mast, this part powers the up and down movements of the lift.
Rotation Motor Assembly -
Consists of mounting plate, 24-volt motor, and small gear.
Hub Assembly -
Consists of hub, bearings, shaft, large gear and mast mounting plate.
Horizontal Support Arms -
These two support arms connect the mast to the seat support arm. The
longer horizontal support arm (actuator arm) connects to the actuator and initiates lifting movements.
Seat Arm -
Connects the seat to the horizontal support arms.
Seating System –
The seat is manufactured from roto-molded plastic with a stainless steel frame. There
are two available forms of safety devices - the standard seat belt and optional stability vest. The seat has
attachment points for both devices and both are easy to attach. Be sure to select the appropriate safety
device for the intended User.
•
It is recommended that people with limited or no body movement at or below the waist shall use
the seat belt restraint when using the lift.
•
It is recommended that people with limited or no body movement at or below the shoulders shall
use the optional stability vest restraint when using the lift.
The seat belt or optional stability vest must be used during each use. The footrest is removable and will
float upwards to prevent damage if the seat is lowered too far. It is recommended that the seat be rinsed
off with fresh water between each use and cleansed daily with a disinfectant solution of 1:100 dilution of
household bleach to fresh water and then rinsed with fresh water. In the event of a contamination incident
such as patient/user excreta - cleanse seat and seatbelt or stability vest immediately with the above
disinfectant solution. Do not use the seat or seatbelt or stability vest if it is damaged or becomes worn out.
The optional armrests (US only - standard on export models) are designed for support when transferring
onto the seat. They can be rotated up out of the way during transfer. If the lift did not include the optional
arm rests (US only) they can be purchased separately and easily installed at a later date.
This lift seat assembly is designed to be used exclusively with S.R. Smith aquatic access lifts.
